Jettribe SHOCKWAVE Moto riding pants are designed and specially built for the
true PWC rider, not just moto-x pants worn in the water. With the PWC rider in
mind, our Jettribe R&D team built these riding pants to provide maximum
flexibility, comfort, and protection. Jettribe understands that riders in the
past wore typical wetsuits for protection while riding, but riding with wetsuits
can be cumbersome, restrictive and hard to get in and out of. Most riders still
need the protection against the bumps and bruises while riding. With this in
mind, Jettribe built the Moto Pants with many features that set our product
knee and shin areas have EVA compression foam molded pads for that added
protection. But our high density EVA foam will not absorb water and stays light.
The main material is a tough Sato 420 D. nylon with 2 coats of PU. This material
is light and very strong, providing wind and water resistance. Wind and water
are really what make you cold. In the inseam panel area, we built an air mesh
panel to allow water to pass through and allow you to stay light while keeping
in your body heat. The rear panel is constructed out of neoprene to allow
maximum flexibility. This panel is also embedded with our Jet Grip - a silicone
texture to maximize grip from your "butt" to your runabout's seat. The dual side
pockets have a built in drain hole on the outside and the inside is mesh. This
allows the water to drain straight through. Once again, we built these pants to
be light while wet. Our single pull tight system allows for instant belt release
or tightening. Just one pull to tighten or one quick press on the 50 MM buckle
to release the waist belt.
Jettribe Moto Pants are literally used & abused by many of our team riders
at the IJSBA World Finals. Yes, these pants are not only tested, but race
tested. The Jettribe Moto Pants are not built to replace the wetsuit but they
are a great alternative. They provide the PWC rider with comfort and protection
against the elements white looking very cool on or out of the water. See you at
the next race!!!
Tough Sato 420 D. and ballistic nylon with 2 coats of PU for wind and water
Inner mesh liner to keep a layer of air between your skin and the outer
Neoprene side panels for warmth and flexibility.
Vents to allow air flow, reducing the ballooning effect at high speeds.
Mesh armpits to allow water to pass through.
Direct Deposit/Internet Banking,
Credit Card (Visa & MasterCard)
, PayPal & Cash
Please select a QTY from above, your Country and Postcode (if you live in AUSTRALIA) or just your Country if outside of AUSTRALIA and click apply to receive a shipping quote in the table below.