Jettribe Moto riding pants are designed and specially built for the true PWC
rider, not just moto-x pants worn in the water. With the PWC rider in mind, our
Jettribe R&D team built these riding pants to provide maximum flexibility,
comfort, and protection. We at Jettribe understand that riders in the past have
worn the typical wetsuits most of the time for protection against abrasion while
riding their stand-up or runabouts.
wetsuits are ideal for colder riding weather, but riding with wetsuits can be
cumbersome, restrictive and hard to get in and out of. Most riders still need
the protection against the bumps and bruises while riding. Plus, most of the cold factors that
riders experience are from the wind and water splashes from the craft flying
across the water (at 65 MPH!), not from being wet. With all of this in mind,
Jettribe has built the Moto pants with many features that set our product apart.
The knee and shin areas have EVA compression foam molded pads for that added
protection. But our high density EVA foam will not absorb water and stays light.
The main material is a tough Sato
420 D. nylon with 2 coats of "PU". This material is light and very strong, and
provides wind and water resistance. Wind and water are really what make you
the inseam panel area, we have built an air mesh panel to allow water to pass
through and allow you to stay light while keeping in your body heat. The "Rear"
panel is constructed out of neoprene to allow maximum flexibility. Plus, this
panel is embedded with our "Jet Grip" silicone texture to maximize grip from
your "butt" to your runabout's seat.
dual side pockets have a built in drain hole on the outside and the inside is
mesh. This allows the water to drain straight through. Once again, we built
these pants to be light while wet. Our single pull tight system allows for
instant belt release or tightening. Just one pull to tighten or one quick
press on the 50 MM buckle to release the waist belt.
Jettribe Moto pants are tested and literally "Used & Abused" by many of our
Team riders at the IJSBA World Finals. Yes, these pants are not only tested, but
Jettribe Moto Pants are not built to replace the wetsuit but they are a great
alternative. They provide the PWC rider with comfort and protection against the
elements white looking very cool on or out of the water. See you at the next
? Tough Sato 420 D. and ballistic nylon with 2 coats of PU for wind and
? Inner mesh liner to keep a layer of air between your skin and the
? Neoprene side panels for warmth and flexibility.
? Vents to allow air flow, reducing the ballooning effect at high
? Mesh armpits to allow water to pass
Direct Deposit/Internet Banking,
Credit Card (Visa & MasterCard)
, PayPal & Cash
Please select a QTY from above, your Country and Postcode (if you live in AUSTRALIA) or just your Country if outside of AUSTRALIA and click apply to receive a shipping quote in the table below.